Kawai’s pipe heater is specially designed for the heating of pipes, valves, and pumps. The heater exterior is wrapped with insulating material, which keeps heat dispersion down to a minimum, reducing energy usage and preventing burns when working.
The heater can be attached and removed easily with snap buttons or Velcro straps, and a connector can be used to connect multiple heaters. It boasts a superior level of heat uniformity with a ±5 ºF (±5ºC) variation at 140ºF (60ºC). Use this heater to warm gases, control the fluidity of liquids, and for other purposes.
Thermal gradient is required
- Coarse-to-fine type
- Thermocouple built-in type
- With thermostat
- With double-sided tape
- With temperature fuse
- With resistance temperature detector (RTD)
|Length||1 to 23.5″ / 25 to 600 mm|
|Min. Diameter (φ)||1/5″ / 5mm|
|Operating Temp.*||Up to 390ºF / 200ºC|
|Max. Watt Density*||13 W/in2 / 2.0 W/cm2|
|Max. Voltage (V)||240|
|Max. Resistance Density||–|
|Outer Dimension Tolerance||–|
|Insulation Resistance (MΩ/DC V)**||More than 1000/500|
|High Pot Test (V/min.) / (V/sec.)||1500 / 1800 (5 mA)|
* Depending on heater specifications.
** Under no-heat conditions. This might be lowered to around 100 MΩ, depending on operating conditions.